Sct H743 Slim V3 Flight Controller FC for RC Drone Fpv

• Customization: Available
• Installation Hole Distance: 30.5mmx30.5mm
• Main Control Chip: Stm32h743vih6
• Model NO.: H743
• Barometer: Infineon Dps310 (I2c2)
• Black Box: 16MB or Microsd
• OSD: At7456e (Spi2)
• Receiver Protocol: Elrs/Crsf/S.Bus/Frsky/Futabayfysky/Tbs Crossfre/Ds
• Djl O3: Support
• Sbus and Vtx Jumper Switching: Support
• 9V and Vcc Jumper Switching: Support
• USB Connector: Type-C
• Camera Switching: Support
• Transport Package: PC Plastic Box
• Specification: 36mmx36mm
• Trademark: SCT
• Origin: China
• Production Capacity: 60000

Product Description

FC Specifications

• MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash
• Board V1.0 IMU: MPU6000 (SPI1) & ICM20602 (SPI4)
• Board V1.5 IMU: MPU6000 (SPI1) & ICM42605 (SPI4)
• Baro: Infineon DPS310 (I2C2)
• OSD: AT7456E (SPI2)
• Blackbox: MicroSD card socket (SDIO)
• 7x Uarts (1,2,3,4,6,7,8) with built-in inversion.
• 13x PWM outputs(including "LED" pad)
• 2x I2C
• 1x CAN
• 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2)
• 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
• 1x SPI3 breakout
• USB Type-C(USB2.0)
• 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4)
• 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G)
• Dual Camera Inputs switch
• 5V/Vbat filtered power ON/OFF switch
• DJI FPV OSD is supported by any spare UART
   
   

Power

• Vbat Input: 6~36V (2~8S LiPo)
• BEC: 5V 2A cont. (Max.3A)
• LDO 3.3V: Max.200mA
• No Current Sensor built-in
• ADC Vbat2 pad supports Max. 69V (voltage divider: 1K:20K)
• Static power: 200mA@5V with Betaflight, 150mA@5V with ArduPilot

FC Firmware

• ArduPilot (ChiBiOS): MATEKH743
• BetaFlight: MATEKH743
• INAV: MATEKH743

Physical

• Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
• Dimensions: 37 x 38 mm
• Weight: 7g

Including

• 1x H743-SLIM
• 6x Silicon grommets M4 to M3
• 1x JST-SH1.0_8pin cable, 5cm
• 2x JST-SH1.0_8pin connectors
• 1x JST-GH-4P to JST-GH-4P cable for CAN port, 20cm